#42
-
Atari Punk Console
- Male
- Fort Myers, FL
- United States
- Blog Posts
- Discussions (1)
- Groups (1)
- Photos (23)
- Photo Albums
- Videos
Atari Punk Console's Page
Latest Activity
Atari Punk Console replied to Sylvain's discussion 555 Synthesizer!"Use LDRs where the pots would go. Look up Atari Punk Console schematics. They are pretty easy. You can also make a sequencer with a 555 and one of the 40xx chips I forget which one, I think its a 4011 or a 4020"
Atari Punk Console's photo was featured
TV Oscilliscope 1
A few minutes is how long it lasted before it blew up. This was the best shot I was able to get of it while I was using my hand built silver siren sweeper as the input which also blew up.
Profile Information
- About myself (public info)
- I built alot of Atari Punk Consoles and other 555 timer circuits.
Atari Punk Console's Photos
Latest Activity
Christian Rheinnecker posted a status"New Video Cypress Hill - Rap Superstar
https://www.youtube.com/watch?v=VZSFgdrhzQQ"
Christian Rheinnecker posted a videoArduino PrX : Sequencer AM808 VX3 - Demo Cypress Hill - Rap Superstar Beat Play
Demonstration eines Beats auf dem AM808 VX3 Arduino Midi Sequencer Cypress Hill - Rap Superstar Weiter Infos auf http://arduinoprx.de
"Im not sure why people turn to IC's for sound or power. I had this little amp kicking around…"
Mark Harrison commented on Thulana Vimukthi's blog post GPS GUIDED AUTONOMOUS ROBOT"Thulana, very excellent project!
It is especially nice, as the hardware connections are relatively…"
GarageLab posted a blog postMake your Thor's Hammer
Rather than being a benign foam hammer, this Mjölnir can summon 80,000 volts of electricity thanks…See More
Terry White replied to Milton Vilela's discussion Firmware GRBL + CNC milling machine -> 3D Printer"you can add a touch probe to cnc to digitize an object, just limited to issues with undercuts."
" Ya Terry,
Sorry, I don't know why I added CNC to 3D? above. A bit too far out of…"
Terry White replied to Milton Vilela's discussion Firmware GRBL + CNC milling machine -> 3D Printer"if you could just use the spindle on/off to control a secondary arduino to run the extruder…"
© 2013 Created by Marcelo Rodrigues.
